Quote:
Originally Posted by Himlar
I have found one way of doing it, which I don't think has been covered here:
I do my design two-layered; on one layer I create the elevation, and on the other I design my track on a flat plate. After that, I extrude my flat track down towards my elevation layer, making sure that they intersect. After that, I use the "Intersect faces with model" option to actually "apply" the track to my elevation layer. Then it's just a lot of work left deleting surfaces and lines, and there's no way of correcting any mistakes (not that I have found, at least).
|
I'll have a go at that on one of my older simpler designs to see how it works
Sent from my HTC Wildfire S A510e using Tapatalk