Quote:
Originally Posted by Bryan Miller
Bob,
I don't have either drawings or templates , however would be willing to provide measurements.
Bryan.
|
Thank you so very much Bryan. I traveled to Seattle, Washington yesterday to perform a measure out of Don Roose's #44 car homed at J&L Fabrications. My, but they have a lovely bunch of vintage and very fast machines under their care.
Measurements with the pesky running gear in the way it was quite the ordeal but I did get most of what my fabricator will need to fab the missing last bulkhead. I will make a AutoCad drawing of the measures and then likely ask you for confirmation of a missed item or to fill in a gap or two. Would that be right with you?
Again, many thank for your kind help on this project.
Peace,
bob slusher
Portland, OR