|
||||||||||
|
||||||||||
26 Apr 2008, 14:34 (Ref:2187459) | #1 | ||
Veteran
Join Date: Aug 2004
Posts: 14,699
|
SB Chevy valve spring choice with solid roller cam?
I am rebuilding this engine for one of my cars and am changing the cylinderheads to comply with current championship regs. This is the engine I did build up but sprung a leak on the cylinderhead in the spring seat area.
Anyhow the guy that originally built the engine has fitted what appears to me a seriously strong triple valve spring and once the valve lash is taken up you can feel the engine getting far harder to turn over. Now I have read an article by David Vizard who advises not going over the top on valve spring pressures as there is serious horse power gains to be had by having them strong enough to stop float at max rpm and shut the valves quick enough but no more as that is simply wasting horse power. I also have a set of twin springs here that I was told by another well known specialist in the SBC engine were for a roller cam and they are no where near as stiff as these ones the engine builder who in fact is more renown as a drag engine builder fitted to mine so its got me wondering has he built this thing to pull collosal revs with a seriously stout cam when I have a road race cam cam that pulls from about 3500 rpm and the engine is limited to 7800 rpm. (BTW he also fitted the engine with an unbaffled drag race sump instead of a road race sump which is why the engine let go so I dont have a great deal of faith). The problem I also have is these triple springs will not fit the legal set of Chevy factory BowTie Phase 2 heads without cutting down the valve guide boss more and enlargening the spring seat more when the Bowtie heads come from the factory already modified in these areas so there should be springs available that will fit. The other set of springs I have fit these perfectly. The spec on the cam at .050 lobe lift is as follows: Intake opens 26 deg BTDC Intake closes 54 deg ABDC Lobe centre 108 deg Lift duration 260 deg Lobe lift .390" Gross valve lift .585" Rocker ration 1.5 to 1 Exhaust opens 66deg BBDC Exhaust closes 24 deg ATDC Lobe center 110 deg Lift duration 270 deg Lobe lift .410 Gross valve lift .615" Rocker ratio 1.5 to 1 Its as I said a solid roller cam but not as radical as some I have seen although the roller cams do have very rapid ramps and look a lot squarer than a flat tappet cam. Any help or advice on a suitable spring for a cam of this spec would be appreciated. BTW I doubt I will rev the unit much over 7200rpm. |
||
__________________
You can't polish a turd but you sure can sprinkle it with glitter! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
NASCAR Valve spring video at 7000rpm | knighty | Racing Technology | 30 | 12 Apr 2007 09:45 |
Valve Spring compressor. ? | DaveStyles | Racing Technology | 8 | 20 Jun 2005 15:51 |
reed valve engine, good choice? | coolerking | Kart Racing | 7 | 31 May 2003 18:43 |
Wasn't Chevy a bad choice for Doran/Bell? | H16 | Sportscar & GT Racing | 2 | 18 Apr 2003 23:05 |