|
||||||||||
|
||||||||||
30 Jul 2012, 23:01 (Ref:3114009) | #1 | |
Rookie
Join Date: May 2008
Posts: 52
|
Figure-of-8 oval; would it work in real life?
I'm sure every fantasy trackmaker has come across this idea once (and quickly passed on).
But would it work in real life??? I'm aiming for indycar/nascar here. I've connected a 1 mile and a 1,5 mile oval. pros and cons please? |
|
|
30 Jul 2012, 23:13 (Ref:3114011) | #2 | ||
Veteran
Join Date: Jun 2012
Posts: 2,336
|
No cons accept it is a completely new idea! (says Bernie Ecclestone).
|
||
|
31 Jul 2012, 07:11 (Ref:3114072) | #3 | ||
Veteran
Join Date: Apr 2006
Posts: 2,107
|
Quote:
Therefore, I actually like your idea to connect 2 ovals on their wider side with each other. This makes much more sense than the concept I tinkered with. However, what about the banking? At least one of the connecting straights would have to be flat, the lower one. And since the corners on both small ovals before and after the connection to that straight cannot rise abruptly, they also would have to be flat. It remains to be seen if having banking on the other 2 turns which connect the upper straight to the small ovals makes any sense. What do you think? In the end, you might end up with two small ovals which only have banking on the front stretch of each but no banking in the corners. That is quite unusual and NASCAR will probably consider it somewhat odd. Yet, it is not certain that the 8-shaped oval would provide better racing since in oval racing, some cars are set up to work better on the outside lane and some are set up to work better on the inside lane. And that promotes overtaking. But here, on the 8-shaped oval, both lanes are upper and lower lane in one of the corners, so there would always have to be a car setup compromise to accomodate both, because, as road circuit specialists might not know, in oval racing it can take a few laps to change from one lane to the other. And if your car works better on, say, the inside lane, you would be forced to change lanes twice every lap or risk losing positions when you cannot get out of the "wrong" lane. But that does not take into account the fact that race cars for ovals are set up in an asymmetrical way so they could not run the oval in the opposite direction at the same speed without switching the sides of the asymmetrical setup. Same thing goes for spotters and drivers' reflexes: they would have to do things at high speed in the opposite direction in the right turn. So to make it safe, people would need to start practicing at an early age on an 8 shaped dirt track. Now that would be an entirely new track design challenge! Edit: I forgot to mention that bankings only make sense if a car gradually goes up into the banking. The original Fuji Speedway has tragically proven a banking into which cars need to drop down to be too dangerous. Hence, coming off of the bridge and diving down into the 18 track banking of your Turn 4 will not work. |
||
|
31 Jul 2012, 07:22 (Ref:3114074) | #4 | ||
Veteran
Join Date: Oct 2008
Posts: 1,589
|
There was a fantasy figure-8 oval on the NASCAR Racing 2003 game if i recall. It produced fun racing but huge crashes in equal measure.
You would need to run a more 'standard' setup on the cars to allow them to turn both ways, not sure how that would effect oval performance. Also, given the Fuji case-study, you would need to consider the geometry carefully. |
||
|
31 Jul 2012, 08:29 (Ref:3114094) | #5 | ||
Race Official
Veteran
Join Date: Jul 2003
Posts: 5,755
|
This is something I too have pondered.
The designs that I've come up with have the smaller oval off set slightly left or right as you have drawn them. It changes the length of the link roads but allows separation for a realistic cross over, with climb to a bridge or drop into a tunnel. |
||
|
3 Aug 2012, 19:56 (Ref:3115762) | #6 | ||||
Rookie
Join Date: May 2008
Posts: 52
|
figure of 8 oval
Quote:
How about a (less deep) tunnel and a (not so high) bridge to create an elevation change as small as possible on either straight. (ScotsBrutesFan post pointed out this idea) Quote:
Quote:
So this design basicly kills ovalracing and make it more of a roadcourse. |
||||
|
6 Aug 2012, 11:24 (Ref:3116604) | #7 | |||
Racer
Join Date: Oct 2006
Posts: 256
|
Quote:
http://www.youtube.com/watch?v=vjS3a9S8QZI |
|||
__________________
2th place in MSA British Superkart championship 2010 5th place in MSA British Superkart championship 2008, 2009, 2011 Winner of 250 challenge superkart championship 2008 |
11 Aug 2012, 11:21 (Ref:3118620) | #8 | ||
Veteran
Join Date: Apr 2006
Posts: 2,107
|
Quote:
But the 8-shaped track certainly would require a more neutral setup than an oval. I have never heard about the above mentioned NASCAR game which has such a track but for a first assumption of how it would work out with 2 wide racing, the game should suffice. |
||
|
11 Aug 2012, 21:24 (Ref:3118790) | #9 | ||
Rookie
Join Date: May 2008
Posts: 52
|
Quote:
In my track I think I've solved the unsafe pit entry and/or exit. I can't see any way how to do this with the Eight Bowl geometry. However I found something about how (online-)racing on the Eight Bowl track would be like; http://www.kiwisimracing.net.nz/foru...c.php?f=4&t=63 This probably would apply to my track. |
||
|
14 Aug 2012, 05:08 (Ref:3119635) | #10 | ||
Racer
Join Date: Apr 2012
Posts: 317
|
I don't think it would fit the definition of an oval track. "Ovals" don't have to be banked, and sometimes aren't, and they don't have to be limited in their number of turns, as you could have a giant octagon (eight turns) and it be an oval track. To be an oval it must have all turns in just one direction. Once there is a turn in the other direction, it is no longer an oval track, no matter how basic its layout might be.
|
||
|
14 Aug 2012, 13:17 (Ref:3119803) | #11 | ||
Race Official
Veteran
Join Date: Jul 2003
Posts: 5,755
|
Given both arguments as to what constitutes an oval and looking to make it Figure 8.
Here is what I've come up with... whilst it's not a figure 8 but it does have the cross over element. Please note the Diagram is not to scale, but if it were to be based on real track, In terms of corner Radius, the lower half of the circuit would be something akin to T4 the front straight (probably a bit longer) and T1 of the Milwaukee Mile set within the infield of T2 the back straight and T3 of Talladega. The Start finish is on the Big Straight, the pit stop would take place during the Lap rather than at the end of a Lap. A Lap... The S/F straight would have some camber but the approach to T1 would be much like approaching T3 of Talladega, The Outer Banking is elevated, so coming off T2 as it would be, the camber equalises off from bith sides of the track, resulting in a gentle down hill over the bridge before the camber begins again for the banking into the Short corner of T3 and T4. The short pit straight leads into T5 which is the tightest corner on the circuit, T6 Opens out but rather than the right hand side coming down (as banking normally would) the inside rises to level the the camber as the track then gently climbs uphill under the bridge before the right hand side of the track starts to camber up into T7 and then around into T8 before back over the S/F Last edited by ScotsBrutesFan; 14 Aug 2012 at 13:28. |
||
|
15 Aug 2012, 21:15 (Ref:3120410) | #12 | |
Veteran
Join Date: Apr 2006
Posts: 2,107
|
That's quite the unique double-oval concept you have come up with there, SBF.
Thank you for your contribution. My ficticious "series" would have it on its shortlist for additions to its next calendar, if I were still to do such a series. Maybe one day, I should start a thread and link to all my favourite tracks by other designers here on MyTracks;-) Your double-oval could actually work well in the US if the inner oval was actually situated somewhat lower inside a "bowl" so people in the stands of the outer oval could also see what's going on inside. |
|
|
17 Jan 2013, 20:58 (Ref:3190728) | #13 | |
Rookie
Join Date: May 2008
Posts: 52
|
I've created the track in my first post for a racegame (Racer).
It turned out to be a very boring, very unchallenging drive. Here's what I came up with to make things more interesting; - lengthen the straights - thighten the turns - lower the banking - use different curve radius within the turn - elevation within the turn But none of these in extreme; I wanted to keep the "oval feel". I didn't want to turn it into a road course. I also realise by doing this it's deviating from realism. There are a few absolute no-go's on this track for real oval racing; The downhill, decreasing radius turn 1 and 2 (most difficult one on the track). I made a quick video. http://www.youtube.com/watch?v=mKNmZq4XnOg Hope you like it, please comment. Last edited by the_calculator; 17 Jan 2013 at 21:04. |
|
|
19 Jan 2013, 22:24 (Ref:3191577) | #14 | ||
Race Official
Veteran
Join Date: Jul 2003
Posts: 5,755
|
I've been fiddling around with my crossover design above adjusting the scale etc and generally crunching some numbers.
At 20m (60+ ft) wide, to scale it would be around 2.33 miles. Allowing for a 1.5m (4.5 ft) deep bridge deck, and a minimum of 5m (15+ ft) of clearance The vertical difference between the inside curves of the inner and out ovals would need to be approx 12m (40ft) If the inner curves are to be highly angled then the vertical differnece would go up to allow spectators on the outer banking a view down. |
||
|
3 Jan 2015, 20:52 (Ref:3489774) | #15 | ||
Race Official
Veteran
Join Date: Jul 2003
Posts: 5,755
|
There are some thing s in this world that once you get an idea in your head, its very difficult to shake.
After numerous doodles and even more aborted attempts on Sketchup, I think I've finally got somewhere. Still lots of work to do, and the angles look worse than they are. Oh and it's 3.67 miles per lap. With apologies to civil engineers and architects everywhere, a couple of preview images. |
||
|
4 Jan 2015, 18:30 (Ref:3489894) | #16 | |
Veteran
Join Date: Apr 2008
Posts: 925
|
Well I have thought about that indeed, don't know why it can't be done, maybe NASCAR racers are too lazy to turn in both directions, they would be overwhelmed by a direction change and the mechanics would go crazy looking for setup solutions hahaha
|
|
__________________
F.I.M. Certified Race Director whowhaa!!! |
12 Jan 2015, 22:37 (Ref:3492213) | #17 | |
Veteran
Join Date: Apr 2006
Posts: 2,107
|
Thank you SBF for bumping this thread back into gear. I'm very much looking forward to your improved 8-oval.
|
|
|
14 Dec 2015, 23:01 (Ref:3597819) | #18 | |
Rookie
Join Date: Dec 2015
Posts: 43
|
Why not just do this? I know, you're looking for high-speed, no big crashes, but come on! Look at this mess!
https://www.youtube.com/watch?v=wZKqhvch3mU |
|
|
14 Dec 2015, 23:56 (Ref:3597830) | #19 | |||
Racer
Join Date: Mar 2011
Posts: 241
|
Quote:
|
|||
|
19 Dec 2015, 10:36 (Ref:3598742) | #20 | ||
Veteran
Join Date: Apr 2006
Posts: 2,107
|
Quote:
|
||
|
2 Mar 2018, 07:27 (Ref:3805131) | #21 | ||
Racer
Join Date: May 2014
Posts: 184
|
I'm going to reignite this thread and I do think that while the figure 8 is a good concept, and I understand your logic, there are a few issues. I really like SBF's concept as well and think that is a better way to fit a crossover on an oval, would be able to fit more track in an arena for the fans, and it would be like having half a lap of Daytona and half of Martinsville speedway. and that got me thinking, it doesn't necessarily have to be 2 ovals right? how many can I do? at the moment I'm at 6 in a star formation.
|
||
__________________
"Craig Lowndes does it, on the day he farewells his friend" Bathurst 1000, 2006 |
2 Mar 2018, 21:11 (Ref:3805311) | #22 | ||
Race Official
Veteran
Join Date: Jul 2003
Posts: 5,755
|
Oh no not again ... I've lost so many hours trying to get something to work for this that I'll never get back !!
|
||
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Finally, Real Racing an Oval! | Jay | ChampCar World Series | 11 | 6 Nov 2002 19:42 |