View Single Post
Old 6 Jan 2010, 11:49 (Ref:2608880)   #2
ScotsBrutesFan
Race Official
Veteran
 
ScotsBrutesFan's Avatar
 
Join Date: Jul 2003
Scotland
West Lothian
Posts: 5,695
ScotsBrutesFan will be entering the Motorsport Hall of FameScotsBrutesFan will be entering the Motorsport Hall of FameScotsBrutesFan will be entering the Motorsport Hall of FameScotsBrutesFan will be entering the Motorsport Hall of FameScotsBrutesFan will be entering the Motorsport Hall of FameScotsBrutesFan will be entering the Motorsport Hall of FameScotsBrutesFan will be entering the Motorsport Hall of FameScotsBrutesFan will be entering the Motorsport Hall of FameScotsBrutesFan will be entering the Motorsport Hall of Fame
Off-Set tool

This first one goes along with the advice given to ptclaus98 and his track Here
From the single line drawing which settles from the think line into the "set" thinner line, select the Off-set tool and click inside the layout. (image 1)

From there off set half the width internally and then half the width externally to create a centre line with the outer and inner edges of the track (image 2)

Or make a single offset at the ful width of the circuit (image 3)
Attached Thumbnails
TUT 1.jpg   Centre with offsets.jpg   Single Off-set.jpg  

ScotsBrutesFan is offline  
Quote