Thread: Making a Seat
View Single Post
Old 14 Mar 2004, 19:43 (Ref:905212)   #4
flatbroke
Racer
 
Join Date: May 2003
Location:
uk
Posts: 286
flatbroke should be qualifying in the top 10 on the grid
Use plastic cups to measure equal amounts dont just guess it will not go off .
Then put your equal amounts in to and clean tub and mix them till they turn a milky yellow use a good strong Black bag make sure theres no holes in it then pure the mix in the bag .when u get in the car try not to stand on the bag you could put a hole in it. I would suggest use 3 cups of each to start and see how far it goes its better to ad a little then a lot and it over flows.
flatbroke is offline  
Quote