Quote:
Originally Posted by phoenix
Rob
Are you planning to use and 83.5 mm bore for your SCB? If you are free to do so you could find a 6% improvement on torque output from the 1593.5cc that would result in (same capacity as the FVA I believe) and more bore clearance for your 1.6" inlet valve.
|
Martin,
I was originally planning on using an 83.5mm bore for the exact reasons you stated. I will have to make a decision here very quickly. I have both 81mm and 83.5mm blocks, so I could go either way.
Regards,
Rob