7 Aug 2009, 22:41 (Ref:2517604)
|
#2
|
Ten-Tenths Hall of Fame
Veteran
Join Date: Aug 2002
|
85mi S. of Daytona, 125mi NE of Sebring |
Posts: 1,837
|
A reply . . .
Quote:
Originally Posted by haggispeed
Simple question really, what are the best quality rivets to use for panelling. I know there are variations in quality. I have in the past come across ones that are a real pig to drill out, usually the pin / nail is so hard the drill wanders off, are these the good ones or the cheap ones?
Looking on the web I see Cherry, Avdel, Huck under the aerospace sites. Need to use hand riveter, don't have facilities for special tooling, (although may have to consider an air riveter for doing a whole chassis)
Advice welcomed
|
The technology in manufacturing these days has rendered the `pop rivet' a commodity item. I would say that your requirements (material, size, etc.)would come first.
|
|
__________________
No trees were harmed by this message. However, several million electrons were terribly inconvenienced
|