![]() |
![]() |
|||||||||
|
||||||||||
![]() |
![]() |
|||||||||
|
||||||||||
![]() |
![]() |
![]() |
#1 | |
Veteran
Join Date: Apr 2002
Posts: 9,710
![]() ![]() ![]() ![]() |
push rods
right . . . here I go again
![]() push rods . . . . does anyone make them ??? I have a set of forged cosworth pistons with a lower crown height (3-4mm) and I'll be skimming the block accordingly (almost definitely I think) along with the big valves I'm using which are slightly longer also I think I'm going to need shorter push rods, or parhaps even taller rocker shaft posts . . . .has anyone ever dabbled ? ? ? or got any suggestions (not give up and get a proper engine!) ![]() |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Push-rods, small block, big block, HDOC, and all about engines.... | Cadete | Sportscar & GT Racing | 24 | 19 Feb 2004 21:17 |
Hot Rods | Blade | National & Club Racing | 5 | 2 Jan 2003 17:27 |
push/pull rods | toabsy | Racing Technology | 5 | 24 Sep 2002 08:13 |
Marshalling Hot Rods! | EvilPumpkin | Marshals Forum | 2 | 19 Aug 2002 15:02 |