|
| Site Partners: | SpotterGuides | Veloce Books |
| Related Sites: | Your Link Here |
|
|
|||||||||
|
||||||||||
|
|
|||||||||
|
||||||||||
|
|
8 Oct 2019, 20:18 (Ref:3932794)
|
#1 | ||
|
Rookie
Join Date: Sep 2015
Posts: 12
 |
Reynard FF 85 uprights
I have an Imp-powered single seater that utilises, what I've been told,
are Reynard FF 85 uprights allround. They are the alloy version, as I believe they were also made in magnesium for F3. I wish to change the bearing on one, and have it set up on a press OK. I am finding that the outer race is exremely tight in the hub, and I was wondering if there is some special method of getting it out ? Does the entire upright need to be heated, or what ? Also, does someone know if the circlips holding in the bearing is a special size ? I've measured the slot as inside dia. 94mm, and the free diameter of the original circlip as 95.5mm. A new circlip I obtained catalogued as "95mm" is actually 99mm free dia., and no way will this fit the hub.... Any suggestions ? |
||
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Magnesium uprights | Jeff 8 | Club Level Single Seaters | 4 | 2 Apr 2009 02:24 |
| Tiga FF rear uprights. | Lips | Racers Forum | 1 | 8 May 2008 19:38 |
| suspension Uprights | jhoran | Racing Technology | 4 | 28 Sep 2001 09:11 |
Threaded Mode