Aim mxl pista not displaying AFR

[datto]

G'day Folks!

Im new to the forum here in the hope someone might be able to help me out with a little problem.

My race car is running a Aim MXL Pista dash/logger linked to an Adaptronic Select ECU and a Innovate MTX-l Air Fuel Ratio gauge and Bosh Wideband O2 sensor.

the issue is my dash isnt displaying the AFR. the ecu is linked to the MTX-l and the ECU reads the AFR no problems, (displays in the windows gauge etc). The dash is linked to the ECU and reads and displays all the data from the ECU except AFR which just reads a constant 17 on the dash. lambda/AFR (from ECU) are selected in Race Studio.

has anyone had this dilemma before? the most important thing i need logged is the AFR!

Any help would be greatly appreciated!

[Casper]

I presume you have used the AIM harness to hook it up? What country are you in? Support varies.

[datto]

thanks for your reply Casper,

I am using a serial cable i made using a 2.5mm stereo plug (for Adaptronic serial out port) and three wires, Tx, Rx and ground. the cable is transmitting all other data so I dont see that as the issue!?

I am in Australia

Cheers

[Casper]

Sorry, I can't help. Antons Race Services in Wilton NSW may be able to steer you in the right direction or EFIOz a member here might be a better bet. I have a feeling it is a channel config problem but someone like the above guys would know straight off.

[datto]

thanks Casper, I have made contact with EFiOz and will see if he can steer us in the right direction!

Cheers!